Does anyone know what this is?

pnc75
Community Member

It's about 18 cm long, both ends screw off and has three round plastic circles on it.

 

TIA

 

 

Message 1 of 140
Latest reply
139 REPLIES 139

Does anyone know what this is?

I'm only a lurker but I seemed to have successfully registered a throwaway, so if you want me to try submitting a post on your behalf, I can give it a go.

Message 71 of 140
Latest reply

Does anyone know what this is?

To save everyone the trouble of trying to find the pic, here's a reminder -  

 

0410.gif.JPG   big grin smiley.gif 

Message 72 of 140
Latest reply

Does anyone know what this is?

That would be wonderful!! Thank you so much!!! Woman Very Happy

Message 73 of 140
Latest reply

Does anyone know what this is?

Done and done: https://www.reddit.com/r/whatisthisthing/comments/8pzhbp/hoping_to_identify_this_hollow_metal_rod_ap...

 

Users may ask more questions, which I'll relate here if I need to clarify something.

 

 

Message 74 of 140
Latest reply

Does anyone know what this is?

One suggestion so far, of a wedding certificate holder (this would make the plastic rings a later, unrelated addition).

 

Pics of certificate holders, most seem a bit more fancy or engraved, though. 

Message 75 of 140
Latest reply

Does anyone know what this is?

I'd say those short 'sample' curtain rods looked like being the most likely. They're only samples of the rod so the rings don't need to be big enough to fit loops on them.
Message 76 of 140
Latest reply

Does anyone know what this is?

At 18 cm, it would be too short for a marriage certificate or birth certificate - that is, for a modern certificate. (They're A4-sized nowadays.)

 

A certificate issued before the current certificates became standard could be a possibility. Perhaps even something like a school certificate...?

 

But I agree that nowadays certificate holders are more ornate.

 

 

The bulbs at either end must be a clue to this item. They may not relate to what's inside (aka my joking suggestion of a holder for a cotton bud - giant-sized), but rather to how this container thing was stored. The bulbs would suggest that it was placed horizontally over two sides of something, or over two bars or hinges on a wall...

Message 77 of 140
Latest reply

Does anyone know what this is?

The fact that the bulbs screw into the rod is what's bothering (or intriguing) me, as that's relatively unusual for something that's just a curtain rod (sample or otherwise) or some kind of holder. It's hard to tell from the picture, but it also looks like it's chrome-plated rather than stainless steel to my eyes, so may have been a bathroom fixture of some sort (towel racks etc are usually chrome plated). 

Message 78 of 140
Latest reply

Does anyone know what this is?

A further suggestion has been made that it's from a more upscale toilet roll holder, and the rings may be used if the roll is bigger, or pushed aside if the roll is narrower. It sounds feasible to me, but still couldn't say for sure.

 

Just to clarify, is 18cm the end to end length? And / or what is the length of the rod section? 

Message 79 of 140
Latest reply

Does anyone know what this is?

When - and if - we find out what it is, it will be either

 

Facepalm_picard : Of Course It Is, We Knew That - by Anonymous

 

Or

 

wot.jpg

Message 80 of 140
Latest reply